| How to easily install your new hardtop. No special tools are required and tops fit your truck like a factory accessory. |
1. |
Remove soft side & back windows. |
|
|
2. |
Remove black plastic trim from perimeter. |
|
3. |
Remove screws with a phillips screwdriver. |
|
|
4. |
Remove screws with a phillips screwdriver. |
|
5. |
Remove screws with a phillips screwdriver. |
|
|
6. |
Remove perimeter brackets with a phillips screwdriver. |
|
7. |
Remove perimeter bracket with phillips screwdriver. |
|
|
8. |
Remove perimeter bracket with a phillips screwdriver. |
|
9. |
Perimeter with brackets removed.
1989-1994 will have a gasket already installed.
1995-1998 requires installation of enclosed gasket. |
|
|
10. |
You can put the screws back in the upright brackets. |
|
11. |
Remove hoop bracket attach screws with a phillips screwdriver. |
|
|
12. |
Remove hoop attach bracket with a phillips screwdriver. |
|
13. |
Perimeter is ready for perimeter seal. Start the seal about 8 inches from the rear of the perimeter. (1995-1998 models only) |
|
|
14. |
Run allen head screws in about 1 inch into the factory nut plates to clean the threads and remove. |
|
15. |
If the screws don't line up with the top on. Adjust by bending nut plates with the screws inserted. |
|
|
16. |
Screw with washer installed. |
|
17. |
Screw with washer installed. |
|
|
18. |
Side view of properly installed rear section. |
|
19. |
Top view of properly installed rear section. |
|
|
GEO FRONT
|
GEO FRONT
|
|
GEO FRONT
3. |
Pull edge trim down and install cam-lock hook. Open cam-lock and rotate catch, if its hard to close. |
|
Installing your Rally Top sport truck hardtop is a simple process, but we are always ready to lend expert advice. |
Testimonials |
Contact |
Sitemap
RSS