Tracker Installation Instructions

Remove the rear soft top. First unzip
the side windows. Then pull down on
the rear corners to disengage the soft
top. Then disengage the front of the
soft top and remove.

Remove the front soft top. Disengage
the two black front clips above the
windshield. Fold the soft top back
and remove the screws holding the
swing arm. The disengage the rear of
the soft top and remove.

Remove all of the perimeter plastic
hardware, with a screw driver.

The perimeter should look like this after
step 3.

Using a Allen wrench, remove the two out
side screws on the front section hold-down
bracket. Then remove the remaining phillips
screws in the bracket and remove the
bracket.

Remove the plastic covers from the rear
bow assembly. Now remove the screws
holding the bow assembly and then remove
the bow assembly.

Install the perimeter gasket. Start at one
end and press on the gasket. Even up the
gasket at the ends.

Install the hold down bracket. It has slot
ted screw holes. Loosely tighten the
screws with the bracket at the upper end
of it’s travel.

With two people, install the rear section.
With the washer attached, start the Allen
head screw. It might be necessary to ad
just the bracket to get the screw to
started. After the screw is started, loosen
the bracket screws and push down on
the top to seat it, then push down on the
Allen head screw. You want the bracket
at the lower end of it’s travel.

Then tighten the bracket screws and then
tighten the Allen head screw.

Using two people install the front section.
Make sure the top is placed evenly on the
sides. Engage the front clips, using moderate
pressure. If you need to pry down
on the clips that are attached to the front
section, you may. Using a pair of vise
grips, pull down slowly, this will lessen
the pressure needed to engage the front
clips.

Install the rear arms on the front section
and tighten.

Enjoy Your New Rally Top