| How to easily install your new hardtop. No special tools are required and tops fit your truck like a factory accessory. |
|
1.
|
Remove soft side & back windows.
|
|
|
|
2.
|
Remove black plastic trim from perimeter.
|
|
|
3.
|
Remove screws with a phillips screwdriver.
|
|
|
|
4.
|
Remove screws with a phillips screwdriver.
|
|
|
5.
|
Remove screws with a phillips screwdriver.
|
|
|
|
6.
|
Remove perimeter brackets with a phillips screwdriver.
|
|
|
7.
|
Remove perimeter bracket with phillips screwdriver.
|
|
|
|
8.
|
Remove perimeter bracket with a phillips screwdriver.
|
|
|
9.
|
Perimeter with brackets removed.
1989-1994 will have a gasket already installed.
1995-1998 requires installation of enclosed gasket.
|
|
|
|
10.
|
You can put the screws back in the upright brackets.
|
|
|
11.
|
Remove hoop bracket attach screws with a phillips screwdriver.
|
|
|
|
12.
|
Remove hoop attach bracket with a phillips screwdriver.
|
|
|
13.
|
Perimeter is ready for perimeter seal. Start the seal about 8 inches from the rear of the perimeter. (1995-1998 models only)
|
|
|
|
14.
|
Run allen head screws in about 1 inch into the factory nut plates to clean the threads and remove.
|
|
|
15.
|
If the screws don't line up with the top on. Adjust by bending nut plates with the screws inserted.
|
|
|
|
16.
|
Screw with washer installed.
|
|
|
17.
|
Screw with washer installed.
|
|
|
|
18.
|
Side view of properly installed rear section.
|
|
|
19.
|
Top view of properly installed rear section.
|
|
|
GEO FRONT
|
GEO FRONT
|
|
GEO FRONT
|
3.
|
Pull edge trim down and install cam-lock hook. Open cam-lock and rotate catch, if its hard to close.
|
|
Installing your Rally Top sport truck hardtop is a simple process, but we are always ready to lend expert advice. |
